There are many large and high-tech molds needed in the market of inspection well molds. Now, in addition to the technical content, the square inspection well molds also need more accurate size, which makes the complex manufacturing process easier. In terms of service life, we should try our best to choose the materials with longer life and higher curling degree to make the molds. Only by making these requirements delicate can we make the molds, In the future, the market of Fangjing mould will be even longer. In addition, there is a high demand for square well molds in the market. A large number of cement well manufacturers will order from familiar mold factories to form a complete set of production and sales process. In addition to the old cement well manufacturers who will use familiar mold factories, some new cement parts manufacturers sometimes have a large demand for molds, The daily output of general mold manufacturers will be between 10-100 tons. If the mold peak season is fixed, the output will be in short supply in the whole market. Therefore, if the cement parts manufacturers have an urgent demand, they need to make a good choice in the mold factory a few days in advance.
Inspection well mold production is made of industrial grade materials, ordinary raw material manufacturers will not consider, and the factory will complete the production according to the mold design drawings. In fact, many steel mold production methods are the same. Naturally, the use of the molds for the valve well is similar. Workers need to clean the whole set of molds for the inspection well before using them. Many people often ignore the cleanliness of the molds. These impurities will affect the quality of the valve well. Therefore, the molds should be cleaned in advance, and the mud injected into the molds should be stirred evenly in advance, Concrete needs to be mixed with cement, aggregate, sand and other materials, and then mixed with clean water until there is no obvious granular slurry. When grouting, the pipe should be put into the bottom of the inspection well mold for rapid grouting, and each operation needs to be recorded by workers.