光伏墩模具的介紹由于其自身具有的許多的優勢而擁有很大的銷售量，這種模具在使用的過程中有一些需要我們注意的地方。我們的這種模具在使用的過程中是容易被磨損的，所以在使用的過程中需要輕拿輕放。還有我們在制作之前要將模具表面的污漬清理干凈，以免在生產的光伏底座里面混入許多的雜事。我們還要在模具的每個角落都刷上油，這樣脫模的過程就不會對產品造成破壞了。光伏墩模具尺寸齊全，方形：30*30*30，35*35*30，40*40*20，40*40*30，40*40*36，40*40*50，45*45*30。圓形：直徑40*35，
The introduction of photovoltaic base mold has a large sales volume due to its many advantages. There are some places that need our attention in the process of using this mold. Our mold is easy to be worn in the process of use, so it needs to be handled with care in the process of use. In addition, we should clean the stains on the mold surface before making, so as not to mix a lot of chores into the photovoltaic base. We also need to paint every corner of the mold, so that the demoulding process will not damage the product.PV pier molds are complete in size, square: 30 * 30 * 30, 35 * 35 * 30, 40 * 40 * 20, 40 * 40 * 30, 40 * 40 * 36, 40 * 40 * 50, 45 * 45 * 30. Circular: diameter 40 * 35,
光伏墩模具的抗壓能力是非常有限的，如果在使用的過程中超過模具的承受壓力那么會使模具發生漏漿甚至斷裂，這樣就會造成材料的浪費。還有就是我們在振動的過程中需要保證混凝土之間的緊密結合，不然生產出來的模具的表面是不夠光滑的。我們在脫模的時候要等待光伏底座模具內部的混凝土的凝固度足夠了在進行。這就是我們制作光伏底座的過程中需要注意的地方，我們需要對這些東西有所了解，這樣生產出來的光伏底座的質量才能有很好的保證。
The compressive capacity of the PV base mold is very limited. If the pressure exceeds the bearing pressure of the mold in the process of use, the mold will leak slurry or even break, which will cause a waste of materials. In addition, we need to ensure the close combination between concrete in the process of vibration, otherwise the surface of the produced mold is not smooth enough. When demoulding, we have to wait for the concrete inside the PV base mold to solidify enough. This is what we need to pay attention to in the process of making photovoltaic base. We need to understand these things so that the quality of photovoltaic base can be well guaranteed.
打印